| 697 |
T |
thrust |
The equation of motion used for optimization and prediction computations will make use of net thrust.
|
n.[U]推力 |
|
| 698 |
T |
tie |
Remove the screws (10) from the tie-down point (9).
Put the tie rods (27) in position and install the quick release pins (26).
把系紧杆(项目27)置于定位并装上快拆销(项目26)。
|
vi.被系住; vt.系; n.[C]绑带、带子 |
|
| 699 |
T |
tight |
Loosen the hand tight lock-nuts (63) and (64).
|
adj.紧的; adv.紧紧地 |
|
| 700 |
T |
tighten |
This is why you must tighten them again.
|
vt.使变紧; vi.变紧 |
|
| 701 |
T |
tip |
Put the adjustable access platform in position at the wing tip.
|
n.[C]翼尖,尖端
|
|
| 702 |
T |
tire |
NOTE: Do not use air to correct the tire pressure.
|
n.[C]轮胎; vt.装轮胎 |
|
| 703 |
T |
titanium |
CAUTION: DO NOT USE METHANOL OR ENGINE TITANIUM PARTS COULD BE DAMAGED.
|
n.钛 |
|
| 704 |
T |
title |
They can be modified or cleared: the page title then becomes WIND.
|
n.[C]标题、题目; vt.加标题于 |
|
| 705 |
T |
toilet |
Carefully lower the toilet seat cover (1).
|
n.[C]厕所、洗手间、盥洗室 |
|
| 706 |
T |
tolerance |
This is to get the correct tolerance.
The tolerance for axial play in a spherical bearing is 0.2 mm (0.0078 in.).
|
n.[C][U]公差、容差 |
|
| 707 |
T |
tool |
Do not use hard or sharp tools to remove the ice.
|
n.[C]工具; vi.使用工具; vt.用工具给……加工 |
|
| 708 |
T |
top |
Six audio channels are defined for the top line bus.
It is located at the top right of the door.
|
n.[C]顶部,上方; adj.最高的; vt.给……加盖(或顶) |
|